Owner manual

12/2000Installation and operating instructions UFM 800 W / UFM 800 C
6
4.1 Fluid alignment
For a correct alignment a Service Adapter Board is required as shown in the diagram.
Note:
SIGNAL CONTROL SIGNAL DETECTION SIGNAL PROCESSING
1/2 path 1/2 selection TrL trigger level TrC trigger course
U/D pulse direction TW time window TrD trigger delay
/SP start pulse Tff trigger flip-flop DS dual slope
T1-4 start pulse sensors BAGC received pulse TrF trigger time
INR received pulse before the AGC /TrDA trigger delay
3/4 trigger point AGCL AGC level amplified
for DS-calibration AAGC received pulse
the AGC
The signals printed in “italic” are not described since they are not necessary for the explanation of the alignment.
The service adapter
must be connected
with a flatcable to the
Service connector on
the converter just
behind the display
board.