User's Guide
Table Of Contents
- Kronos InTouch® DX User Guide
- Contents
- Overview
- Employee Mode Transactions
- Introduction
- Access your employee home page
- Standard transactions
- Smart View transactions
- Edit Paycode (Smart View)
- Message Center (Smart View)
- Move Paycode (Smart View)
- Request Open Shift (Smart View)
- Request Shift Swap (Smart View)
- Respond to Shift Swap Request (Smart View)
- View Accruals (Smart View)
- View My Time (Smart View)
- View Schedule (Smart View)
- View Timecard (Smart View)
- View Totals (Smart View)
- Manager Mode Transactions
- Maintenance Mode Functions
Chapter 4 Maintenance Mode Functions
110
Note: To view numeric and special characters on the keypad, tap the 123?
key.
9. Tap Next.
10. Enter the user’s password, and tap Done.
11. Tap Save. Under the name of the network you selected (in step 5), the
processing status appears (Connecting, Saving, and so on).
12. To return to the Maintenance mode home page, press the Home icon on the
front of the timeclock.
13. Tap Reports.
14. Tap Network.
15. Ensure that the Wi-Fi Connection Status is Connected, and that the IPV4
Configuration displays the correct IP address.
Proxy Server
The proxy server feature allows you to direct all incoming traffic from the
InTouch DX through a proxy server before it reaches an internal network. It
supports communication through HTTP and SOCKS5 proxy servers, on both
device-initiated and server-initiated devices. Basic authentication is supported for
both HTTP and SOCKS5.
When the InTouch DX is in maintenance mode, the Network report provides the
status and configuration of the proxy client.
Note: InTouch DX timeclocks currently do not support direct user configuration
to communicate via a proxy server; and VNC, SSH and VoIP do not use the proxy
client.
To configure the InTouch DX to work with an existing proxy server:
1. Tap Edit Settings.
2. Tap Connect to Network.
3. Tap Proxy Server.