User's Guide
Table Of Contents
- Kronos InTouch® DX User Guide
- Contents
- Overview
- Employee Mode Transactions
- Introduction
- Access your employee home page
- Standard transactions
- Smart View transactions
- Edit Paycode (Smart View)
- Message Center (Smart View)
- Move Paycode (Smart View)
- Request Open Shift (Smart View)
- Request Shift Swap (Smart View)
- Respond to Shift Swap Request (Smart View)
- View Accruals (Smart View)
- View My Time (Smart View)
- View Schedule (Smart View)
- View Timecard (Smart View)
- View Totals (Smart View)
- Manager Mode Transactions
- Maintenance Mode Functions
Chapter 4 Maintenance Mode Functions
130
GPIO Output Bits
Output bits are electronics that control external devices such as bells or door
strikes, which can be attached to the InTouch DX. If you have installed such
external devices, use this test to ensure that they are operating.
1. Tap Run Tests.
2. Tap GPIO Output Bits.
3. Slide the button that corresponds with the output bit (1-4) that you are testing
to toggle the output bit between an on or off state.
Monitor GPIO Inputs
Note: This test functions only if the transition board option is installed.
1. Tap Run Tests.
2. Tap Monitor GPIO Inputs.
Microphone
This test ensures that the integrated microphone is operating properly.
1. Tap Run Tests.
2. Tap Microphone.
3. To record a test message, tap Record.
4. To listen to the recording, tap Play.
Remote Badge
If you have installed the remote badge reader option, this test ensures that it is
operating properly.
1. Tap Run Tests.
2. Tap Remote Badge.