User's Guide
Table Of Contents
- Kronos InTouch® DX User Guide
- Contents
- Overview
- Employee Mode Transactions
- Introduction
- Access your employee home page
- Standard transactions
- Smart View transactions
- Edit Paycode (Smart View)
- Message Center (Smart View)
- Move Paycode (Smart View)
- Request Open Shift (Smart View)
- Request Shift Swap (Smart View)
- Respond to Shift Swap Request (Smart View)
- View Accruals (Smart View)
- View My Time (Smart View)
- View Schedule (Smart View)
- View Timecard (Smart View)
- View Totals (Smart View)
- Manager Mode Transactions
- Maintenance Mode Functions
Chapter 3 Manager Mode Transactions
66
Employee instructions
1. Tap the target (+) that corresponds to the finger you are enrolling. In order of
preference, select your index finger, middle finger, or thumb. Enroll your ring
finger or pinky only if you cannot successfully enroll the other fingers. If you
do tap the ring finger or pinky, a warning message appears; you can then
continue or change the finger.
Note: Ensure that your finger is clean, and not too dry.
2. To scan your finger:
a. Directly face the timeclock so that you can comfortably place your finger
on the sensor—without awkwardly extending your arm or hand.
b. Position your finger core above the center of the sensor.
c. Place your finger flat on the sensor. Do not twist, rotate, or slide your
finger while it is on the sensor. If your finger is positioned incorrectly, the
system instructs you to reposition it for a successful scan.