User's Guide
Table Of Contents
- Kronos InTouch® DX User Guide: Workforce Dimensions™
- Contents
- Overview
- Employee Mode Transactions
- Introduction
- Access your Individual home page
- Standard transactions
- Smart View transactions
- Edit Paycode (Smart View)
- Message Center (Smart View)
- Move Paycode (Smart View)
- Request Open Shift (Smart View)
- Request Shift Swap (Smart View)
- Respond to Shift Swap Request (Smart View)
- View Accruals (Smart View)
- View My Time (Smart View)
- View Schedule (Smart View)
- View Timecard (Smart View)
- View Totals (Smart View)
- Manager Mode Transactions
- Maintenance Mode Functions
- Troubleshooting
Chapter 4 Maintenance Mode Functions
122
5. Select the Password Strength:
–Strong
–Weak
6. To require users to enter this password when they swipe a Maintenance badge,
enable Require Password with Badge.
7. Tap Save Settings.
Change Database Password
Use the Change Database Password function to change the password for a
database.
1. Tap Edit Advanced Settings.
2. Tap Change Database Password.
3. Enter the new password, which must be eight characters in length, and contain
at least one of each of the following: uppercase letter, lowercase letter,
number, and special character. Tap Enter.
4. Re-enter the new password and tap Enter.
5. Tap Save Settings.
Factory Defaults
Use Factory Default to restore the device settings to the factory default settings.
Caution: Use the Factory Default settings only if the timeclock is not operating
properly. You lose all previous settings and data when you perform this function.
1. Tap Edit Advanced Settings.
2. Tap Factory Defaults.
3. To confirm your selection, tap Restore. The timeclock reboots.