Rotary Glasswasher Manual

7
Krowne Metal Corporation | 100 Haul Road | Wayne, NJ 07470
Phone: [phone] | Fax: [phone] | www.krowne.com
Installation
Installation
CAUTION!
The glasswasher water inlet plumbing and the drain piping extend below the pallet.
Use extreme care when moving the glasswasher to prevent damage to the glasswasher
plumbing.
1. Move the glasswasher to its permanent location.
2. Open the door and remove the box marked "LEGS".
The box contains (4) 6" [152cm] screw-in legs.
These legs are threaded tightly into the base of the machine.
3. Remove (2) 1/2-13 x 2" bolts holding the glasswasher
to the pallet.
4. Lift the front door off the bottom hinges and set carefully aside.
5. The illustrations below show one method to install the legs
without lifting the glasswasher completely off the pallet.
Unpacking
Remove the (2) pallet bolts holding
the glasswasher to the pallet.
Water
Connections
Boxed Legs
Pallet
Drain
Glasswasher plumbing connections extend
below the pallet.