Use and Care Manual

TECHNICAL DATA KRK-25
KRUD KUTTER
®
DECK & FENCE
PRESSURE WASHER CONCENTRATE
Form: GDH-544
Rev.: 101016
1
.DESCRIPTION AND USES .
Krud Kutter
®
Deck & Fence Pressure Washer Concentrate
is a proprietary formulation which contains Sporex
®
, a
unique additive which removes tough stains from mildew,
mold, algae, fungus and moss, and restores the original
look to wood decks and fences. It also dissolves the
toughest stains from dirt, oil, grease, bird droppings, tree
sap, and more.
Deck & Fence Pressure Washer Concentrate is
recommended for cleaning vinyl, aluminum and wood
siding, awnings, gutters, porch screens, driveways, pool
areas, engines and equipment.
PRODUCTS .
SKU Description
DF014 1-Gallon Bottle
.PRODUCT APPLICATION .
DIRECTIONS
IMPORTANT – READ ENTIRE LABEL BEFORE USE
 When using a pressure washer to clean painted
surfaces, please be aware that water pressure alone
may remove paint, or highlight existing discoloration
caused by the sun's UV rays.
 From the garden hose, rinse any nearby plants with
clean water.
 Always test on an inconspicuous area first.
 Any overspray can be neutralized with large volumes
of water.
 On extremely soiled or mildewed surfaces it may be
necessary to scrub with a bristle brush, and a second
application may be needed. Mildew may not be
completely removed from porous surfaces.
 Do not mix this product with any other chemicals.
PRODUCT APPLICATION (cont.) .
COVERAGE
When mixed 1:10 (12 oz. of concentrate with 1-gallon of
water), one bottle of concentrate will make 11 gallons of
premix and clean up to 3,200 sq. ft.
DIRECTIONS: PRESSURE WASHER APPLICATION
Wet the surface to be cleaned, prior to applying the
product. Place detergent application siphon tube and
screen filter directly into container. Open meter valve
(if applicable) for maximum product flow. For reservoir
machines, pour product (full strength) into pressure
washer. Spray at low pressure onto a wet surface. On
vertical surfaces, always spray from the top down. Allow
product to remain on the surface for 3 to 5 minutes to
penetrate. Do not allow product to dry on surface. Remove
siphon tube from solution and rinse surface with high-
pressure spray thoroughly. Flush siphon tube with clean
water prior to storage.
DIRECTIONS: MANUAL APPLICATION
Wet the surface to be cleaned, prior to applying the
product. Mix approximately 12 oz. of product with 1-gallon
of water in a bucket. Severe stains may require a larger
amount of concentrate per gallon. Clean in sections with a
soft bristle brush, working from the top down on vertical
surfaces. Allow product to remain on the surface for 3 to 5
minutes to penetrate. Do not allow product to dry on
surface. With a hose at highest pressure, rinse the cleaner
from the surface. Move to a new section and repeat the
process.
NOTE: For use in a pump up sprayer, mix 12oz. of
concentrate with 1-gallon of water
NO BLEACH OR AMMONIA. SAFE FOR PEOPLE,
PETS AND PLANTS.
CAUTION! EYE AND SKIN IRRITANT. This product
contains alkaline detergents. Do not take internally. In
case of contact with eyes or skin, flush with water for at
least 15 minutes. If irritation persists, seek medical
attention. If swallowed, take large amounts of water. Do
not induce vomiting. Get medical attention.
KEEP OUT OF REACH OF CHILDREN.