How to Guide

TECHNICAL DATA KRK-27
KRUD KUTTER
®
MULTI-PURPOSE
PRESSURE WASHER CONCENTRATE
Form: GDH-546
Rev.: 092616
1
.DESCRIPTION AND USES .
Krud Kutter
®
Multi-Purpose Pressure Washer Concentrate
is a ready to use, commercial strength formula
recommended for all exterior siding (wood, vinyl,
aluminum), roofing of all types (asphalt shingles, fiberglass
shingles, cedar, tile), gutters, stucco, brick and cement
block, masonry, concrete driveways, walkways and walls,
porch screens, pool areas, engines and equipment, even
RV’s, patio furniture and boats.
PRODUCTS .
SKU Description
PWC014 1-Gallon Bottle
289296 1-Gallon Bottle
290933 2-Gallon Carton
PWC05 5-Gallons
.PRODUCT APPLICATION .
DIRECTIONS
IMPORTANT – READ ENTIRE LABEL BEFORE USE
 When using a pressure washer to clean painted
surfaces, please be aware that water pressure alone
may remove paint, or highlight existing discoloration
caused by the sun's UV rays.
 From the garden hose, rinse any nearby plants with
clean water.
 Always test on an inconspicuous area first.
 Any overspray can be neutralized with large volumes
of water.
 For heavy oil and grease stains (such as on driveways
and garage floors), pour product directly onto the stain.
Allow to penetrate for 5 to 10 minutes; then follow
normal application procedures.
 In case of severe oil and grease stains on porous
surfaces, oil may bleed to the surface or leave a
residual stain. Repeat applications may lighten stains,
but not remove completely.
 Do not mix this product with any other chemicals.
PRODUCT APPLICATION (cont.) .
COVERAGE
When mixed 1:10 (12 oz. of concentrate with 1-gallon of
water), one bottle of concentrate will make 11 gallons of
premix, and clean up to 3,200 sq. ft.
NO SCRUBBING – SPRAY ON•WASH OFF
No scrubbing, simply apply to the surface, leave for
3 to 5 minutes, and wash off. Contains anti-corrosive
agents to safeguard pressure washer parts (bleach can
erode O-rings). Penetrates and helps remove tough
stains from dirt, oil, grease, bird droppings, tree sap,
mold and mildew.
DIRECTIONS: PRESSURE WASHER APPLICATION
Rinse surrounding plants with water, before and after
application. Wet surface to be cleaned, prior to applying
the product. Place detergent application siphon tube and
screen filter directly into container. Open meter valve
(if applicable) for maximum product flow. For reservoir
machines, pour product (full strength) into pressure
washer. Spray at low pressure onto a wet surface. On
vertical surfaces, always spray from the top down. Allow
product to remain on the surface for 3 to 5 minutes to
penetrate. Do not allow product to dry on surface.
Remove siphon tube from solution and rinse surface
with high-pressure spray thoroughly. Flush siphon tube
with clean water prior to storage.
NOTE: For use in a pump up sprayer, mix 12 oz. of
concentrate with 1-gallon of water
NO BLEACH OR AMMONIA. SAFE FOR PEOPLE,
PETS AND PLANTS.
CAUTION! EYE AND SKIN IRRITANT. This product
contains alkaline detergents. Do not take internally. In
case of contact with eyes or skin, flush with water for at
least 15 minutes. If irritation persists, seek medical
attention. If swallowed, take large amounts of water. Do
not induce vomiting. Get medical attention.
KEEP OUT OF REACH OF CHILDREN.