Operation Manual

NOTE:ALTHOUGH THIS PRODUCT IS FULLY COMPATIBLE WITH USB 1.1 & 2.0 STANDARDS,
A SMALL PERCENTAGE (ABOUT 5%) OF USB FLASH DRIVES MIGHT NOT BE READABLE,
DUE TO THOSE USB-DRIVE MANUFACTURERS NON-COMPLIANCE WITH THE FULL
(OFFICIAL) USB 1.1 / 2.0 STANDARDS.
THE READING TIME FOR A USB-DRIVE OR SD-CARD VARIES DEPENDING ON THE SPEED
OF THE MEMORY DEVICE AND THE NUMBER OF SONGS AND FOLDERS. IN SOME CASES
THE READING TIME MAY BE AS LONG AS 60 SECONDS.
IMPORTANT
ALWAYS SWITCH OFF THE UNIT OR CHANGE MODE TO “CD” OR “RADIO”BEFORE
REMOVING A USB FLASH DRIVE OR SD-CARD, TO PREVENT DAMAGE TO YOUR USB
DEVICE OR MEMORY CARD.
THIS UNIT DOES NOT SUPPORT USB-MP3 PLAYER, DUE TO THEIR INHERENT LACK OF
SOFTWARE COMPATIBILITY. ONLY USB "PEN DRIVES" (FLASH MEMORY USB DRIVES)
CAN BE USED, FOR MP3 PLAYBACK.
IMPORTANT POINT
Please do NOT use a USB Extension Cable to connect your USB FLASH DRIVE to the
USB PORT of this unit.
Such cables can pick up additional interference which can corrupt the data flow, preventing
normal operation and usage of the USB port. Always connect your USB Flash Drive DIRECTLY to
the USB PORT without any USB extension.
NOTE: THIS UNIT SUPPORTS UP TO MAXIMUM MEMORY SIZE OF 16 GB USB FLASH DRIVE
& SD CARD.
- THE CD PLAYER CAN BE PROGRAMMED TO PLAY ANY SEQUENCE OF UP TO 20 TRACKS
FOR AUDIO-CD / 99 TRACKS FOR MP3-CD, AS DESIRED.
- ALWAYS PRESS THE „STOP” KEY BEFORE STARTING THE PROGRAMMING.
- PRESS THE "PROGRAM” KEY ,THE DISPLAY WILL SHOW "P01" AND THE "P" SYMBOL WILL
FLASH, TO INDICATE THAT THE SET IS NOW IN "MEMORY PROGRAMMING MODE", AT THE
FIRST MEMORY POSITION.
- PRESS THE „BACK” OR „NEXT” KEYS OR TO SELECT THE TRACK (SONG) NUMBER YOU
WISH TO BE STORED IN THE FIRST MEMORY (PROGRAM) POSITION, AND PRESS THE
"PROGRAM/REPEAT" KEY TO CONFIRM YOUR SELECTION.
- WHEN YOU PRESS THE "PROGRAM" THE DISPLAY WILL ADVANCE TO THE NEXT MEMORY
POSITION (eg. "P02").
- REPEAT THE PREVIOUS 2 STEPS, EACH TIME SELECTING ANY TRACK NUMBER OF YOUR
CHOICE TO BE STORED IN THE SUCCESSIVE MEMORY (PROGRAM) POSITIONS.
- AFTER EACH TRACK NUMBER, REMEMBER TO PRESS THE PROGRAM/ REPEAT KEY.
- AFTER A MAXIMUM OF SONGS (OR LESS) HAVE BEEN SELECTED AS DESCRIBED ABOVE.
- ALSO, THE "P" SYMBOL WILL REMAIN "ON" TO INDICATE THAT YOU HAVE SAVED A
PROGRAM-MEMORY (SEQUENCE).
- PRESSING „PLAY” WILL NOW PLAY BACK THE "SAVED SEQUENCE" IN THE PROGRAM
MEMORY.
- TO CLEAR (CANCEL) THE ENTIRE PROGRAM WHICH IS STORED IN THE MEMORY,
SIMPLY PRESS "STOP" TWICE, OR SWITCH "OFF" THE SET.
PROGRAMMING THE CD PLAYERPROGRAMMING THE CD PLAYER
9
KM3902
Krüger&Matz