Operation Manual

8
FIRST USE
STOP
STOP
STOP
Rinse water tank before rst use. Fill water tank
with fresh, drinking water and insert water
tank into machine.
Switch machine on. Power button starts blink-
ing red while machine is heating up. This takes
approx. 30 seconds. When the power button
light is steady green, the machine is ready.
30 sec
ON
Move lever to the right to start rinsing.
Open locking handle and insert empty capsule
holder. Close locking handle.
Place empty container under outlet.
Set the bar display to the maximum level with
the volume selector. Move lever to the left to
start rinsing the machine.
Wait until the lever comes back to the middle
and rinsing stops. Empty and clean the jug.
Fill water tank with fresh, drinking water up to
max. level.
Make sure that the selection lever is in “STOP”
position. Then plug the power plug into a
mains power socket.
Wait until the lever comes back to the middle
and rinsing stops. Machine stops rinsing and
power button blinks red for about 10 seconds.
1
4
7
2
5
8
Place drip grid on drip tray. Then insert drip
tray at desired position of machine.
3
6
9