User Manual

9
EN
■ Place the coffee maker on a hard flat surface.
■ Connect the power cord to a 120V wall socket.
1 - When you plug in the coffee maker for the first time, "1:00 pm" will start flashing on the display. Fig. 1.
Set the time by pressing the
H button (n) to set the hour and the MIN button (o) to set the minutes.
The time will appear on the display. It will be automatically set after 5 seconds or by pressing the
BREW button (l).
2 - You can also set or change the time at any other time. Set the time by pressing the
H button (n) to set
the hour and the
MIN button (o) to set the minutes. The time will appear on the display. Figs. 2 and
3. It will be automatically set after 5 seconds or by pressing the
BREW button.
NB: Your clock is now set and will continue to show the time, even when your machine is in standby mode.
If the machine is unplugged or there is a power failure, the clock will revert to 1:00 pm. Repeat the steps
above to reset the clock.
■ Remove stickers from your coffee maker.
■ Before using your coffee maker for the first time, run a cycle without coffee to rinse the circuit. Fill the water
tank to the maximum level and start a cycle by pressing the
BREW button (l).
IMPORTANT : Your machine has been designed to work with cold or water at room temperature only.
■ Open the coffee maker lid (b). Fig. 4.
■ Open the lid of the thermal carafe by twisting the lid so that the arrow and the word 'OPEN' are aligned.
Fig. 5a.
■ Fill the thermal carafe (g) with cold or warm water and close the lid by aligning the arrow with the word
'OPEN', then by twisting the lid so the arrow is aligned with the word 'CLOSE'. Fig. 5b. Pour water
into the water reservoir by pressing the lever on the lid of the thermal carafe so the water starts
flowing. Figs 6 and 7. The number of cups is shown by the water level indicator. Do not exceed 12 cups.
Fig. 8.
■ Place the thermal carafe (g) with its closed lid onto the base (i) making sure that it is properly positioned
so as to activate the coffee pouring mechanism. Fig. 11.
■ Make sure that the filter holder (j) is inserted. Fig. 9. Insert the permanent filter (k) Fig. 10a or a #4 paper
filter into the filter holder (j). If using a paper filter, make sure it is fully opened and properly positioned in
the filter holder. Fig. 10b.
2. DESCRIPTION
a
Machine body
b
Lid
c
Water tank
d
Water level indicator
e
Thermal carafe lid
f
Thermal carafe handle
g
Thermal carafe
h
Lever for the Thermal carafe lid
i
Base
j
Filter holder
k
Permanent filter
l
BREW
button
m
AUTO ON
button
n
H
button
o
MIN
button
p
BOLD
button
q
1 - 4
cups button
r
CLEAN
button
s
Filter cartridge holder
t
Filter cartridge
u
Cartridge replacement indicator
v
Spoon
3. SETTING THE CLOCK
4. BEFORE FIRST USE
5. MAKING COFFEE
KR_CAFETIERE_ET353_NC00136996.qxp_Mise en page 1 13/09/2016 16:30 Page9