Operation Manual

23
Cleaning
Always make certain the KRUPS blender is disconnected before cleaning.
Thoroughly wash the glass jug and its various components (see diagram) in hot soapy water
and rinse with plenty of water.
Do not use scouring pads that are likely to scratch the material.
Rinse and dry each component thoroughly.
You can wash the glass jug, plastic base with stainless steel blades and the body of the
accessory in the dishwasher. First disassemble the parts to load them into the dishwasher
separately.
Caution:
Handle blades with great care as they are extremely sharp and can cause injury.
Clean the body of the appliance with a damp cloth.
Never immerse the body of the appliance in water and do not put it under running water.
What to do if your appliance does not work?
PROBLEM
Appliance does not
work
Excessive vibration
Leak from lid
Leak from bottom of jug
Blade does not turn
easily
CAUSE
The plug is not connected
The jug or accessory is not
fitted correctly on the body of
the appliance
The product is not placed on a
flat surface
The jug or accessory is not
correctly fitted to the motor
unit
Too great a volume of
ingredients
The lid is not correctly
positioned
Silicone seal missing or
incorrectly assembled
Seal deformed or damaged
Pieces of food too big or too
hard
SOLUTION
Connect the appliance to a
socket with the same voltage
Check for correct positioning
of the jug, or accessory
Place the product on a flat
surface
Check for correct positioning
of the jug or accessory
Jug over full with ingredients
Do not go over the maximum
level of the jug (1.5 l) for thick
preparations and 1.25 l for
extremely liquid preparations)
Lock the lid onto the blender
jug correctly
Check for presence and
correct operation of seal
Replace seal. Available from
KRUPS authorised service
centre
Reduce size of pieces of food
or quantity. Add liquid
KRUPS BLENDER FRESH multilangue 6/04/06 14:29 Page 23