Operation Manual

■ Release the filter holder: press the button lightly while turning the filter holder towards the left and
remove it from the appliance. Throw away the used coffee using the ejection system by pressing the
"push" button on the handle fully (fig. 15). Wash the filter holder under running water, while pressing
the "push" button to eliminate the remains of ground coffee (see also paragraph 8.B for deeper cleaning).
■ It is normal that each time the control selector d1 returns to the position there is a low noise of running
water or steam, due to a specific device which eliminates the pressure from the circuits.
With an E.S.E espresso pod
"ESE" for "Easy Serving Espresso" is a pod (44 mm in diameter) of 7g of coffee that has been
selected, ground and compacted between two filter papers especially designed to make Italian
style espresso ("ristretto" short coffee).
This system permits easy, simple, clean and comfortable use of your machine.
■ Before removing the removable tank, remember to place the selector d1 in the position (fig. 6).
■ Fill the tank with cold water and fit it back onto the appliance (fig. 7).
■ Switch on the appliance by pressing the ON/OFF button d2 .
■ The LED flashes during preheating, then remains lit. The appliance is then ready for use.
■ Release the filter holder by pressing the button lightly and turning it towards the left (fig. 14). If
required, remove the paper around the pod following the dotted lines (fig. 10). Place the E.S.E pod
with the red writing facing downwards (fold the corners of the filter paper back). Ensure that the paper
is placed inside the filter, otherwise this could cause leaks. For creamier and thicker froth, the E.S.E pod
must be positioned correctly. The pod is designed to make one cup of coffee. The use of 2 E.S.E pods
on top of one another is not recommended.
■ Insert the filter holder into the appliance tightening it by turning it towards the right as far as possible
(fig. 11).
■ To prepare your espresso, follow the same procedure as for the preparation of an espresso with ground
coffee.
With a soft pod
Your machine is also compatible with soft pods (generally 60 mm in diameter).
As this type of pod is not specifically designed for espresso machines, you will obtain a weaker
espresso than with an E.S.E. pod.
■ Before removing the removable tank, remember to place the selector d1 in the position (fig. 6).
■ Fill the tank with cold water and fit it back onto the appliance (fig. 7).
■ Switch on the appliance by pressing the ON/OFF button d2 .
■ The LED flashes during preheating, then remains lit. The appliance is then ready for use.
■ Release the filter holder by pressing the button lightly and turning it towards the left (fig. 14). Place
a soft pod into the filter holder. The pod is designed to make one cup of coffee. The use of 2 pods on
top of one another is not recommended.
■ Insert the filter holder into the appliance tightening it by turning it towards the right as far as possible
(fig. 11).
■ To prepare your espresso, follow the same procedure as for the preparation of an espresso with ground
coffee.
English
10