User's Manual

3. Press [EXIT] to exit the menu. Enter RX frequency [4][6][2][6][2][5] on you numeric keypad.
4. Press [MENU] [1][2] [MENU] to come to Menu 12: RX CTCS, press [UP]/[DOWN] to select 67.0, and then
press [MENU] to confirm.
5. Press [MENU] [1][4] [MENU] to come to Menu 14: TX CTCSS, press [UP]/[DOWN] to select 67.0, and then
press [MENU] to confirm.
6. Press [MENU] [2][5] [MENU] to come to Menu 25: Offset, enter offset frequency [1][0][0][0][0] on you
numeric keypad.
7. Press [MENU] [2][4][MENU] to come to Menu 24: Direction, press [UP]/[DOWN] to select Plus or
Minus
offset.
8. Press [MENU] [2] [6] [MENU] to come to Menu 26: Memory, and then Press [1][9][MENU] to confirm (Ex
20).
9. Press [V/M] return to MR Mode. Channel number will re-appear.
Certain Amateur Radio repeaters (especially in Europe) use a 1750Hz tone burst to open up the repeater.
If you're still unable to make a connection, contact the person in charge of the radio system with your
employer or your local amateur radio club, as the case may be.
If you for some reason want to listen to the repeater's input frequency instead, press [MENU] and [*]