User Manual

User Manual of Digital Video Recorder User Manual
23
DC Load Connection Diagram AC Load Connection Diagram
For DC loads, the outputs can be used with the jumpers in place, within the limit of 12V/1A safely.
To connect an AC load, jumpers should be removed (you must remove the jumper on the motherboard in the DVR). Do NOT connect high
voltage to/through the DVR relays. Use an external relay for safety (as shown in the figure above).
There are 4 jumpers (JP1, JP2, JP3, and JP4) on the motherboard, each corresponding with one alarm output. By default, jumpers are
connected. To connect an AC load, jumpers should be removed.
Example:
If you connect an AC load to the alarm output 3 of the DVR, then you must remove the jumper JP 3.
1.8 Alarm Connection
To connect alarm devices to the DVR:
1. Disconnect pluggable block from the ALARM IN /ALARM OUT terminal block.
2. Press and hold the orange part of the pluggable block; insert signal cables into slots and release the orange part. Ensure signal cables
are in tight.
3. Connect pluggable block back into terminal block.
1.9 RS-485 Connection
5. Disconnect pluggable block from the RS-485 terminal block.
6. Press and hold the orange part of the pluggable block; insert signal cables into slots and release the orange part. Ensure signal cables
are in tight.
7. Connect A+ on PTZ to D+ on terminal block and B- on controller to D- on terminal block. Fasten stop screws.
8. Connect pluggable block back into terminal block.