KPC-N635NH10 IR Dual Voltage Varifocal IP66 Bullet Camera User Guide / Installation / Operation Instructions www.ktncusa.
Operation Instructions Please read this manual first for correct installation and operation. This manual should be retained for future reference. The information in this manual was current when published. The manufacturer reserves the right to revise and improve its products. All specifications are therefore subject to change without notice. Precautions 1. Do not install the camera near electric or magnetic fields.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Table of Contents Chapter 1 Product Overview 1.1 1.2 1.3 1.4 1.5 Chapter 2 Features Accessory Parts List Specifications Dimensions Camera Component Description 5 6 7 8 9 Installation 2.1 Wiring and Mounting 2.
Chapter 1 1 PRODUCT OVERVIEW The KT&C KPC-N635NH10 uses 42 IR LEDs with adjustable level control to produce 600TVL day/night images in low or no light out to a range of 120 feet or more. The KPC-N635NH10 offers flexible positioning for wall or ceiling mounting in an IP66 weather resistant, vandal resistant bullet housing with operation down to -4°F; varifocal 2.
1.2 Accessory Parts List Please be careful when you unpack the box and the electronic device inside.
1.3 Specifications Imaging Device Video Format Effective Picture Elements Horizontal Resolution Sensitivity IR LEDs IR Range IR Switch Points S/N Ratio Video Output Gamma Correction Lens Type Positioning Day/Night Electronic Shutter Sync. Mode Power Source Power Consumption Operating Temperature Environmental Mechanical Dimensions Weight Certifications 1/3" High Sensitivity CCD NTSC 768(H) x 494(V) More than 600TVL 0 lux with IR on .
1.
1.5 Camera Component Description Speedy-mount Ring Speedy-mount Ring Grasp and twist to remove the cover. Test point and IR level controls are inside the cover 1 2 1) IR Level Control: adjust IR level to control excessive illumination 2) Video Test : for aim and focus access to video at the camera, use the Video Test Cable supplied to a hand held test monitor (EN220 or similar).
Chapter 2 2 INSTALLATION This chapter will describe, in general terms, how to install the KPC-N635NH10 camera. STEPS: 1. Wire and mount the camera. See 2.1 2. Adjust the camera position. See 2.2 Warning To prevent electrical shock, turn off the electrical power before making electrical connections. 2.1 Wiring and Mounting Use the template and an appropriate tool to drill 4 holes to attach the rapid-mount ring.
Video & Power cables Power Socket Connect the power and video cables. Attach the camera to the rapid-mount ring, securing it with the 4 socket head cap screws provided.
2.2 Adjust Camera Position Adjust the viewing angle to the desired direction. With this unique 3-axis positioning system, installers ca from virtually any angle, without compromising. The camera can be adjusted in 3 ways.
3rd axis 12 Loosen lock ring and set screw to rotate camera 360° Sunshield To remove or install the sunshield, use flat blade screw driver to loosen the screw at sunshield. Secure with this screw Note: When properly installed, the rear of the sunshield is even with the rear of the camer the sunshield to ‘shade’ the lens can compromise image quality.
