User's Manual

31
30
MANUAL SEARCH
The channel is deleted from the memory, and the color of the channel number changes
from green to red.
FINE-TUNE
If the reception is clear, do not fine-tune the channel. Because this is done automatically
during the autoprogram operation.
The AFT(Automatic Frequence Tuning) mode does not operate on the channels that are
fine-tuned.
Press VOL + / - button to fine-tune a channel.
BOOSTER EFFECTS
In case that the incoming signal is weak, set BOOSTER auto or active state.
However, If you are located in a strong signal area like a nearby broadcasting station
and if the picture is distorted, set booster off or inactive state .
Press VOL + button to set booster active or inactive.
3DNR FUNCTION
Motion adaptive spatial and temporal
noise reduction (3D-NR) reduces a lot of
noise in the picture!
Press CH button to select 3D-NR (3
Dimension Noise Reduction).
Press VOL + button to change 3D-NR
mode and then the mode changes as
shown below.
2 MODE
3 MODE 1 MODE
SET UP
AUTO-PROGRAM
All broadcast channel in the current mode
(CATV/TV) will be scanned and stored.
After this operation, press MENU button to
exit.
T0 stop this procedure during the opera-
tion, press VOL + button.
MANUAL SEARCH
1. To add a channel
To add a skipped channel to the memory after the autoprogram operation, follow these
steps.
Select a channel to view by using 10 digit keys on the remote controller.
Press ADD/DEL button on the remote controller.
The color of a memorized channel number changes from red into GREEN.
2. To delete a channel
Exclude a channel from the memory.
Follow these steps to delete a channel in TV memory.
Press CH
/ button or 10 digit keys to select a channel you want to delete.
Press ADD/DEL button on the remote controller.
SET UP