Installation Instructions

3 TRANSMISSION
B1700·B2100·B2400 WSM,11770
[2] CLUTCH HOUSING
(1) Clutch Housing Rear Cover
Clutch housing rear
17.7to20.6N·m
Tightening torque
1.8to2.1 kgf'm
cover mounting screw
13.0to 15.2 ft-Ibs
Clutch Rod and Release Fork
1. Remove the external snap ring (1).
2. Draw out the clutch rod (2) and remove the clutch release
fork (3).
3. Take out the release hub with release bearing (4).
(3) Clutch Release Fork
(4) Release Bearing
(1) External Snap Ring
(2) Clutch Rod
Clutch Housing Rear Cover
1. Remove the clutch housing rear cover (1).
(When reassembling)
•
Apply liquid gasket (Three Bond 1208D or equivalent) to
joint face of clutch housing and rear cover (1).
[A] HST Type
[B] Manual Transmission Type
Clutch Shaft and Others
1. Pullout the clutch shaft assembly (1).
2. Pull out the 2nd gear shaft, front assembly (2) (HST Type).
3. Pullout the 2nd shaft, front assembly (3) (Manual
Transmission Type).
4. Pull out the 3rd shaft, front assembly (4) (HST Type).
(When reassembling)
•
Apply small amount of the grease to the oil seal (5).
(1) ClutchShaftAssembly
(2) 2nd Gear Shaft, Front Assembly
(3) 2nd Shaft, Front Assembly
[A] HSTType
[B] Manual Transmission Type
(4) 3rd Shaft, Front Assembly
(5) Oil
Seal
3-S 16