Operation Manual

ManualsBrandsKubota ManualsMiscellaneousB2301

3-POINT

HITCH

1.

Make

preparations

for

attaching

implement.

•Selecting

the

holes

of

lifting

rods

and

lower

links

There

are

2

holes

in

the

lower

links.

For

most

operations

the

lifting

rods

should

be

attached

to

the

(A)

holes.

1AGAEEFAP038D

(1)

Lower

links

(2) Lifting

rods

holes:(A),(B)

NOTE:

•

The

lifting

rods

may

be

attached

to (B)

hole

for

higher

lifting height, (with

reduced

lifting force)

•Selecting

the

Top

Link

Mounting

Holes

Select

the

proper

set

of

holes

by referring to

the

"Hydraulic Control Unit

Use

Reference

Chart" in

"HYDRAULIC

UNIT"

section.

1AGAEEFAP003E

(1)

Mounting

hole

1

(2)

Mounting

hole

2

3-POINT

HITCH

&

DRAWBAR

33

•

Drawbar

Remove

the

drawbar

if a

close

mounted

implement

is

being

attached.

2.

Attaching

and

detaching

implements

A

WARNING

To

avoid

personal

injury

or

death:

•

Be

sure

to

stop

the

engine

and

remove

the

key.

• Do

not

stand

between

tractor

and

implement

unless

parking

brake

is

applied.

•

Before

attaching

or

detaching

implement,

locate

the

tractor

and

implement

on

a

firm,

flat

and

level

surface.

•

Whenever

an

implement

or

other

attachment

is

connected

to

the

tractor

3-point

hitch,

check

full

range

of

operation

for

interference,

binding

or

PTO

driveline

separation.

• Lifting

Rod

(Right)

Level a 3-point

mounted

implement

from

side

to

side

by

turning

the

adjusting

handle

to

shorten

or

lengthen

the

adjustable

lifting rod with

the

implement

on

the

ground.

After

adjustment,

tighten

the

lock nut

securely.

1AGAEEFAP038B

(1)

Adjusting

handle

(2)

Lock

nut

•Top

Link

1.

Adjust

the

angle

of

the

implement

to

the

desired

position by

shortening

or

lengthening

the

top

link.

2.

The

proper

length of

the

top

link

varies

according

to

the

type

of

implement

being

used.