Operation Manual

EVERY 50 HOURS
• Lubricating Grease Fittings
Apply a small amount of multipurpose grease to the
following points every 50 hours:
If you operated the machine in extremely wet and muddy
conditions, lubricate grease fittings more often.
1AGAEEIAP041A
(1) Grease fitting (Bral<e pedals)
1AGAEEIAP014C
(1) Grease fitting (Top link)
(2) Grease fitting (Lifting rod, right)
1AGAEEIAP006G
(1) Battery terminals
o
PERIODIC SERVICE 55
• Chiecking Engine Start System
A WARNING
To avoid personal injury or death:
• Do not allow anyone near the tractor while
testing.
• If the tractor does not pass the test do not
operate the tractor.
• Detach an implement before testing.
♦ Preparation before testing.
1. Sit on operator's seat.
2. Set the parking brake and stop the engine.
3. Shift the range gear shift lever to "NEUTRAL" position.
4. Place the speed control pedal in "NEUTRAL" position.
5. Shift
the PTO clutch lever to "OFF" position.
^ Test: Switch for the speed control pedal.
1. Depress the speed control pedal.
2. Turn the key to "START" position.
3.
The engine must not crank.
4. If it cranks, consult your local KUBOTA Dealer for this
service.
^ Test: Switch for the PTO clutch lever.
1. Place the speed control pedal in "NEUTRAL" position.
2. Shift
the PTO clutch lever to "ON" position.
3. Turn the key to "START" position.
4. The engine must not crank.
5. If it cranks, consult your local KUBOTA Dealer for this
service.
♦ Test: Switches for the operator's seat and the PTO
clutch lever.
1. Sit on the operator's seat.
2. Start the engine.
3. Engage the PTO clutch lever.
4. Stand up. (Do not get off the machine.)
5. The engine must shut off after approximately 1
second.
6. If it does not stop, consult your local KUBOTA Dealer
for this service.