Operation Manual

66 PERIODIC SERVICE
1AGAEEAAP030C
(1) Oil inlet
(2) Dipstick
€
(A) Oil level is acceptable within this range
7. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
8. Make sure that the transmission fluid doesn't leak past
the seal on the filter.
IMPORTANT:
• To prevent serious damage to the hydraulic system,
use only a KUBOTA genuine filter.
•Adjusting Front Axle Pivot [4WD]
A WARNING
To avoid personal injury or death:
• Park the tractor on a flat place.
• Lower the implement, lock the parking brake
and stop the engine.
If the front axle pivot pin adjustment is not correct, front
wheel vibration can occur causing vibration in the steering
wheel.
♦ Adjusting procedure
Loosen the lock nut, and tighten the adjusting screw so
that the oscillating load is 50 to 100 N (5.1 to 10.2 kgf, 11.2
to 22.5 Ibf). (If the adjusting screw is tightened, loosened
and retightened, apply liquid gasket to its tip.) Retighten
the lock nut.
Consult your local KUBOTA Dealer for further details.
1AGAEEIAP024A
(1) Adjusting screw
(2) Lock nut
• Replacing Fuel Filter Element
(See "Cleaning Fuel Filter" in "EVERY 100 HOURS" in
"PERIODIC SERVICE" section.)