Installation Instructions

ManualsBrandsKubota ManualsMiscellaneousB2400

B1700·B21 00·B2400 WSM, 11770

1

ENGINE

(2) Timing

Gears

and

Camshaft

235.4

to

245.2 N'm

Tightening

torque

Crankshaft

bolt

24.0

to

25.0

kgf'm

173.6

to

180.8 ft-Ibs

Fan

Drive Pulley

1.

Set

the

stopper

to

the

flywheel.

2.

Remove

the

screw and detach

the

fan drive pulley (1).

(When reassembling)

• Check

to

see

the

fan drive pulley

is

aligned

with

its

aligning

mark.

Fuel Pump, Hour

Meter

Gear

Case

1.

Remove

the

fuel

pump

(1).

2.

Remove

the

hour

meter gear

case

(2).

(When reassembling)

• Before installing

the

hour

meter

gear

case

gasket,

apply

Iiquid gasket (Three Bond 1215

or

equivalent)

to

the

both

side.

(2) Hour

Meter

Gear

Case

(2)

Aligning

Mark

(1)

Fuel

Pump

(1)

Fan

Drive Pulley

Water

Pump

1.

Remove

the

water

pump

flange.

(When reassembling)

• Before installing

the

water

pump

flange

gasket, apply

liquid

gasket (Three Bond 1215

or

equivalent)

to

the

both

side.

Gear

Case

1.

Remove

the

gear

case.

2.

Remove

the

crankshaft collar and O-rings.

(When reassembling)

•

Be

sure

to

set

four

O-rings inside

the

gear

case

and

the

O-ring

on

the

crankshaft.

•

Apply

a

thin

film

of

engine oil

to

the

oil seal, and install

it,

noting

the

lip

comes

off.

• Length

of

the

screws (refer

to

the

figure)

A:

45 mm (1.77 in.)

B:

50

mm (1.97 in.)

C:

55 mm (2.17 in.)

D:

59

mm (2.32 in.)

E:

68 mm (2.68 in.)

F:

80 mm (3.15 in.)

Gear

case

mounting

9.8to

11.3 N'm

Tightening

torque

1.0

to

1.15 kgf·m

screw

7.2

to

8.32 ft-Ibs

C095F114

B

1-S23