Installation Instructions

B1700·B2100·B2400 WSM,11770 2 CLUTCH
CHECKING, DISASSEMBLING AND SERVICING
CHECKING AND ADJUSTING
Clutch Pedal Stopper Bolt
1. Measure the clearance "A" between stopper bolt (1) and
clutch housing
(2).
2. If the measurement is not within the factory specifications,
adjust
it with the clutch clutch pedal stopper bolt (1).
II NOTE
GIl After adjustment, secure the stopper bolt with the lock nut.
A CAUTION
GIl When checking, park the tractor on flat ground, apply the
parking brake, stop the engine and remove the key.
1. Slightly depress the clutch pedal and measure free travel at
top of pedal stroke.
2. If the measurement is not within the factory specifications,
loosen the lock
nut (2) and adjust the clutch rod (1) length.
3. After adjusting it, be sure to keep the distance for stopper
bolt.
4. After adjusting them, try to start engine. If no start, check
the safety switch setting position.
Clutch
Pedal Free Travel
8.5mm
0.33 in.
20to30 mm
0.79to1.18in.
(2) Lock Nut
Factory spec.
Factory spec.
Clearance: U AU
Clutch pedal free
travel
(1) Clutch Rod
(1) Clutch Pedal Stopper Bolt
(2) Clutch Housing
Safety Switch Setting Position
1. Measure the distance" A" of safety switch when clutch pedal
fully depressed.
2. If the distance" A" is not within the factory specifications,
adjust the mounting position
of safety switch.
~~,~ty switch distance: Factory spec.
(1) Safety Switch
17to21 mm
0.67 to 0.83 in.
2-53