Installation Instructions

B1700'B21 00·B2400 WSM, 11770
[3] GENERAL PRECAUTIONS
G GENER.!~L
SGOOF001
®
--
{Al
(B)
®
• During disassembly, carefully arrange removed parts in a
clean area
to prevent confusion later. Bolts and nuts should
be installed in their original position to prevent reassembly
errors.
• When special tools are required, use KUBOTA genuine
special tools. Special tools which are not frequently used
should
be made according to the drawings provided.
• Before disassembling or servicing electrical wires, always
disconnect the ground cable from the battery first.
• Remove oil and dirt from parts before measuring.
• Use only KUBOTA genuine parts for parts replacement to
maintain tractor performance and to assure safety.
• Gaskets and a-rings must be replaced during reassembly.
Apply grease
to new a-rings or oil seals before assembling.
See the figure left side.
• When reassembling external snap rings or internal snap
rings,
they must be positioned so that sharp edge faces
against the direction from which a force
is applied. See the
figure left side.
• When inserting spring pins, their splits must face the
direction from which a force is applied. See the figure left
side.
• To prevent damage to the hydraulic system, use only
specified fluid or equivalent.
SGOOF002
(1) Grease
(2) Force
(3) Sharp Edge
(4) Axial Force
(5) Rotating
Movement
[A] External Snap Ring
[B] Internal Snap Ring
SGOOF003
pO
®
G-3