Installation Instructions

(4) Fuse Box
(5)
Overflow Hose
B1700·B2100·B2400 WSM,11770
3 TRANSMISSION
Fuel Tank
1. Disconnect the fuel hose between fuel filter and fuel tank at
the fuel filter side, then drain fuel completely.
2. Remove the fuel tank frame stay (1).
3. Disconnect the regulator and hazard unit connectors, and
remove the lead wire for fuel gauge.
4. Disconnect the fuse box (4).
5. Dismount the overflow hoses (5) of fuel line.
6. Remove the tank flame (2) with fuel tank (3).
(1) Fuel Tank Frame Stay
(2) Fuel Tank Flame
(3) Fuel Tank
Suction Pipe, Delivery Pipe and Power Steering Pipes
and Others
1. Remove the foot accelerator rod (2).
2. Remove the power steeri ng delivery pi pe (1).
3. Remove the power steering return pipe (3). (HST type)
4. Disconnect the flare nut of 3-point hitch delivery pipe (4)
from flow priority valve and loosen the joint bolt (3) on the
hydraulic cylinder.
5. Remove the fuel fi Iter bracket (8) with fuel fi Iter.
6. Loosen the clamps of suction hose (5) and remove the suction
hose
from the hydraulic pump (6).
7. Remove the shutter plate (7).
(When reassembling)
Flare nut
29.4 to 39.2 N'm
(P.S. delivery, return
3.0
to 4.0 kgf'm
pipe and 3-point hitch
21.7
to 28.9 ft-Ibs
delivery pipe)
Tightening
torque
5B.B to 78.5 N'm
Joint
bolt
6.0 to 8.0 kgf'm
43.4 to 57.9 ft-Ibs
Fuel filter bracket
17.7
to 20.6 N'm
mounting screw
1.8to2.1 kgf'm
13.0 to 15.2 ft-Ibs
(When reassembling)
•
Apply grease to the spline of the propeller shaft and
coupling.
Propeller Shaft Cover and Coupling
1. Loosen the clamp and slide the propeller shaft cover (1) to
the rear.
2. Tap out the spring pin (2) and then slide the coupling (1) to
the rear.
(1) Foot Accelerator Rod
(2) Power Steering Delivery Pipe
(3) Power Steering Return Pipe
(4) 3-Point Hitch Delivery Pipe
{1} Propeller Shaft
(2) Spring Pin
3-513
(5) Suction Hose
(6) Hydraulic Pump
(7) Shutter Plate
(8)
Fuel Filter Bracket
(3) Coupling