Installation Instructions

81700·82100·82400 WSM,11770
;'M~
~~~~~L ·l_~---,~_ ......
Power Steering Delivery Pipe
Power Steering Return Pipe
Power Steering Assembly
3 TRANSMISSION
Separating the Engine from Clutch Housing
1. Disconnect the glow plug lead wire and tharmo sensor lead
wire. And then disconnect
the connectors for dynamo or 2P
for alternator connector and starter motor lead wire.
2. Place the jack under the center frame.
3. Hoist the engine by the cain at the engine hook.
4. Remove the engine mounting screws and separate the
engine from the clutch housing.
(When reassembling)
•
Apply liquid gasket (Three Bond 1208D or equivalent) to
joint face ofthe engine and clutch housing.
17.7 to 20.6 N'm
Engine
mounting screw 1.8to2.1 kgf'm
13.0 to 15.2 ft-Ibs
Tightening
torque
48.1 to 55.8 N'm
Engine
mounting nut 4.9 to 5.7 kgf'm
35.5 to 41.2 ft-Ibs
Power Steering Assembly
1. Remove the power steering delivery pipe (1) and return pipe
(2) (Manual TransmissionType).
2. Disconnect the speed set rod (HST type) and parking brake
rod.
3. Remove the power steering assembly (3) from the center
frame.
(When reassembling)
Flare nut 29.4to39.2 N'm
(P.S. delivery, return 3.0to4.0 kgf-m
Tightening
torque
pipe)
21.7
to 28.9 ft-Ibs
Power steering assembly
77.5to90.1 N'm
7.9
to 9.2 kgf-m
mounting screw
57.2
to 66.5 ft-Ibs
Separating Clutch Housing
1. Disconnect the clutch rod.
2. Disconnect the rubber hose (1) of hydraulic pipe (HST Type).
3. Separate the clutch housing from center frame.
(When reassembling)
• Apply grease
to the splines of propeller shaft and ball joint.
• Reinstall the connecting pipe and O-rings securely.
Clutch housing
62.8
to 72.6 N'm
Tightening
torque 6.4 to 7.4 kgf'm
mounting screw and nut
46.3 to 53.5 ft-Ibs
(1) Rubber
Hose
3-S 15