Installation Instructions

81700·82100·82400 WSM,11770
3 TRANSMISSION
Rear wheel cotter
123to147N'm
Tightening torque
setting bolt and nut
12.6 to 15.0 kgf·m
91 to 108 ft-Ibs
Step, Fender, Tire and Seat
1. Remove the lowering speed adjusting knob and seat under
cover
(3).
2. Remove the rubber mat.
3. Disconnect the speed set rod (4) (HST Type) and parking
brake rod (5).
4. Remove the clutch and brake springs.
5. Remove the left and right hand side steps.
6. Remove the cotter (1) setting bolt and nut, then place the
jack under the transmission case, and set the rigid rack
under the rear axles.
7. Take out the wheel hub pin (2) and remove the rear wheels.
8. Remove the seat (6).
9. Remove the main gear shift lever grip (7) (Manual
Transmission Type).
10. Remove the Hi-Lo gear shift lever grip (8), mid and rear-PTO
gear shift lever grips (9), (10), position control lever
grip (11)
and
front wheel drive lever gri p (12).
11. Remove the left and right hand side lever guide (13).
12. Remove the main gear shift lever (14) (Manual Transmission
Type).
13. Disconnect the wi re harness and remove the fender stay,
left and right hand side fenders.
14. Remove the tool box and seat stay with seat rai I.
• IMPORTANT
• When refitting or adjusting a wheel, tighten the bolts to the
following torques then recheck after driving the tractor
200 m (200 yards) and there after daily check service.
(When reassembling)
(1) Cotter
(2) Wheel Hub
Pin
(3) Seat Under Cover
(4) Speed Set
Rod
(5) Parking 8rake Rod
(6) Seat
(7) Main Gear Shift Lever Grip
3-S19
(8) Hi-Lo Gear Shift Lever Grip
(9) Mid-PTO Gear Shift Lever Grip
(10) Rear-PTO Gear
Shift Lever Grip
(11) Position Control Lever Grip
(12) Front Wheel Drive Lever Grip
(13) Lever Guide
(14) Main Gear Shift Lever