Installation Instructions

B 1700·B21 00·B2400 WSM, 11770
G GENERAL
• Securely clamp, being careful not to damage
wiring.
• Clamp
wiring so that there is no twist, un-
necessary sag, or excessive tension, except for
movable part, where sag may be required.
CORRECT ~
INCORRECT~
C079F007
C079F008
C079F009
• In installing a part, take care not to get wiring
caught by it.
• After installing wIring, check protection of
terminals and clamped condition of wiring, only
then connect battery.
INCORRECT
C079F010
C079F011
• Battery
C079F001
• When removing battery cord, disconnect negative
wire first. When installing battery cord, check
for
polarity and connect positive wire first.
•
Do not install any battery with capacity other than
is specified (Ah).
• After connecting cord
to battery terminals, apply
grease to them and securely install terminal covers
onthem.
•
Do not allow dirt and dust to collect on battery.
A CAUTION
• Take care not to let battery liquid spill on your
skin and clothes. If contaminated, wash it off
with water immediately.
• Before recharging the battery, remove
it from the
machine.
• Before recharging, remove cell
caps.
A CAUTION
• Do recharging in a well-ventilated place where
there is no open flame nearby, as hydrogen gas
and oxygen are formed.
Install on posilive
terminal firs t
o
Take care
not to confuse positive
and negative terminals.
C079F013
G-S