Installation Instructions

ManualsBrandsKubota ManualsMiscellaneousB2400

3 TRANSMISSION

B1700·B21 00·B2400 WSM, 11770

Mid-PTO rear cover

17.7

to

20.6 N'm

Tightening

torque

mounting

screw

1.8

to

2.1

kgf'm

13.0

to

15.2 ft-Ibs

Mid-PTO

Shaft

and

One-way

Clutch

1.

Remove

the

mid-PTO

case

rear cover

mounting

screws and

separate

the

rear cover (1).

2.

Remove

the

bearing (2) and remove

the

friction

plates (3),

brake discs

(4) and spring (5).

3.

Remove

the

external snap ring (6) and remove

the

spring (7)

and

one-way

clutch cam (8).

4.

Remove

the

spring (9) and ball (10).

5.

Draw

out

the

dowel

pin and remove

the

shift

arm (11)

with

shifter.

6.

Remove

the

oil

seal

(12) and internal snap

ring

(13).

7.

Remove

the

mid-PTO

shaft

(14)

with

bearing, 11T

gear

(15)

and

shifter

(16).

(When

reassembling)

•

Apply

grease

to

lip

and

outer

of

oil seal.

•

When

installing

the

needle bearings (17)

into

the

11T

gear

and

one-way

clutch cam,

apply

transmission

oil

to

the

needle

bearings.

•

NOTE

•

When

installing

the

needle

bearings

(17),

noting

the

position

of

needle bearings

onto

the

mid-PTO

shaft

shown

in

the

figure.

(10) Ball

(11) Shift Arm

(12) Oil

Seal

(13) Internal Snap Ring

(14) Mid-PTO Shaft

(15) 11T Gear

(16) Shifter

(17) Needle Bearing

(1) Mid-PTO

Case

Rear Cover

(2) Bearing

(3) Friction Plate

(4) Brake

Disc

(5) Spring

(6) External Snap Ring

(7) Spring

(8) One-way Clutch

Cam

(9) Spring

B177P158

3-S34