Installation Instructions

G GENERAL
81700,82100·82400 WSM, 11770
(2) Tread Adjustment
(2)-1 Front Wheel
Front tread cannot be adjusted.
_IMPORTANT
•
Do not turn front discs to obtain wider tread.
Models
81700
82100
82400
81700
82100
82400
81700
82100
82400
Tires
6-12
Farm
7-12
Farm
21 x8.00-10 23x8.50-12
Turl Turl
12-16.5
Industrial
835mm
32.9 in.
940mm
37.0 in.
870mm
34.3 in.
870mm
34.3 in.
_-1----- 870mm
(34.3in)
8177FG240354F097
940mm
(37.0inl
8177FG23
835mm
(32.9in)
0354F096
835mm
(32.9in)
0354F096
Tread
Cotter setting bolt
123 to 147 N'm
and nut
12.6 to 15.0 kgf'm
Tightening
91 to 108 ft-Ibs
torque
108to125N'm
Wheel hub
mounting nut
11.0 to 12.8 kgf'm
80 to 93 ft-Ibs
A CAUTION
• When working on slopes or working with trailer,
set the wheel tread
as wide as practical for the job
for maximum stability.
_IMPORTANT
• Always attach tires
as shown in the drawings
below.
•
If not attached as illustrated, transmission parts
may
be damaged.
•
Do not use tires larger than specified.
• When re-fitting or adjusting a wheel, tighten the
bolts
to the following torques then recheck after
driving the tractor
200 m (200 yards) and there
after daily check service.
(When adjusting tread)
(4) Wheel Hub Pin
(5) Snap Pin
(1) Nut
(2) Spring Lock Washer
(3) 80lt
Rear tread can be adjusted in 2 or 3 steps
depending on the model.
To change the tread
1. Loosen the nut of cotter pin bolt.
2. Remove the snap pin and wheel hub pin.
3. Change the tread to the desired position.
4. Re-set the wheel hub pin, snap pin and cotter pin
bolt.
(2)-2 Rear Wheels
G-34