Installation Instructions

1 ENGINE
B1700·B21 00·B2400 WSM, 11770
(1) Battery Cord
[AJ Oil level is acceptable within this range.
12.01
HSTtype 3.17 U.S.gals.
Transmission oil
2.4lmp.gals
capacity
Manual transmission
11.01
type
2.90 U.S.gals.
2.6Imp.gals
(3) Dipstick
Hood and Side Cover
1. Open the hood from front and remove the spling lock pin
and remove the food
with hood rod for keeping it open.
2. Remove the front grille (4).
3. Remove the right and left side cover (2), (3).
(1) Hood (3) Left Side Cover
(2) Right Side Cover (4) Front Grille
(1) Drain Plugs
(2) Filling Plug
Battery
1. Disconnect the battery cords (1).
II NOTE
• When disconnecting the battery cords, disconnect the
grounding cord first. When connecting the positive cord
first.
Drain
the Transmission Oil
1. Place oil pans underneath the transmission case.
2. Remove the four drain plugs (1) at the bottom of the
transmission case.
3. Drain the transmission oil.
4. After draining, screw in the four drain plugs (1).
(When refilling)
• Fill new oil from
filling port after removing the filling plug
(2) up to the upper notch on the dipstick.
•
After running the engine for few minutes, stop it and check
the oil level again,
if low, add oil prescribed level.
II IMPORTANT
•
Use only KUBOTA SUPER UDT fluid. Use of other oils may
damage the transmission or hydraulic system.
Refer
to "LUBRICANTS, FUEL AND COOLING WATER". (See
page G-a.)
• Never
work the tractor immediately after changing the
transmission oil. Keeping the engine at medium speed for a
few minutes to prevents damage to the transmission.
• Do
not mix different blands oil together.
1-512