Installation Instructions

81700·82100·82400 WSM,11770 1 ENGINE
17.7 to 34.5 N'm
Tightening torque
Slotted
nut
1.8 to 3.5 kgf'm
13 to 25.3 ft-Ibs
I11II1I IMPORTANT
CD After tightening the slotted nut to the specified torque,
install the cotter pin as shown in the figure.
(2) Fuel Filter
(3) Coupling
(2) Drag Link
(1)
Fuel Hose
Propeller Shaft Cover and Coupling
1. Loosen the clamp and slide the propeller shaft cover (1) to
the rear.
2. Tap out the spring pin (2) and then slide the coupling (3) to
the rear.
(When reassembling)
CD Apply grease to the splines of the propeller shaft and
coupling.
Radiator Hoses,
Muffler Pipe and Hydraulic Pipes
1. Loosen the clamps and disconnect radiator hoses (1).
2. Remove the muffler pipe (2).
3. Disconnect the radiator stay (3) and then dismount the
radiator.
4. Dismount the battery (6).
5. Loosen the clamps of hydraulic hoses and remove the battery
stay
with oil cooler then remove the delivery pipe (5) (from
HST) and return pipe (4) (from oil cooler) (HST type).
(1) Radiator Hose (4) Return Pipe
(2) Muffler Pipe (5) Delivery Pipe
(3) Radiator Stay (6) Clamp
Fuel Hoses and Fuel Filter
1. Close the fuel fiIter cock.
2. Disconnect the fuel hose (1) between fuel pump and fuel
fiIter
(2) at the fuel filter side.
3. Remove the fuel filter mounting screw and remove the fuel
filter from the bracket.
(1) Propeller Shaft Cover
(2) Spring Pin
Drag Link
1. Steer the front wheels to the left.
2. Remove the slotted nut and disconnect the drag link (2) from
the knuckle arm
(1).
(When reassembling)
(1) Knuckle Arm
030F129
1-513