Installation Instructions
III IMPORTANT
•
After
reassembling
the
fan belt, be sure
to
adjust
the
fan
belt
tension.
Dynamo,
Fan
Belt and
Muffler
1.
Remove
the
dynamo (1) (or alternator) and fan
belt
(2).
2.
Remove
the
cooling fan (3) and fan pulley.
(When reassembling)
• Check
to
see
that
there are no cracks on
the
belt
surface.
B1700·B2100·B2400 WSM,11770
DISASSEMBLING
AND
ASSEMBLING
(1) Cylinder Head and Valve
(1)
Dynamo
(2)
Fan
Belt
(3)
Cooling
Fan
1 ENGINE
Head Cover
1.
Remove
the
head cover (1).
(When reassembling)
• Check
to
see
if
the
head cover gasket
is
not
defective.
6.9
to
8.8
N'm
Tightening torque
Head cover
cap
nut
0.7
to
0.9 kgf'm
5.1
to
6.5
ft-Ibs
(1) Head Cover
Injection Pipes
1.
Loosen
the
screws on
the
pipe clamps.
2.
Detach
the
injection pipes (1).
(When reassembling)
•
Send
compressed
air
into
the
pipes
to
blowout
dust.
Then, reassemble
the
pipes in
the
reverse order.
24.5
to
34.3
N'm
Tightening torque
Retaining nuts
2.5
to
3.5
kgf'm
18.1
to
25.3
ft-Ibs
1-519