Installation Instructions

B1700·B21 00·B2400 WSM, 11770
B177F927
B177F927
B177F928
B177F928
B177F928
82
82
82
82
82
9 ELECTRICAL SYSTEM
2) Headlight Switch Continuity When Setting Switch Knob at
OFF Position
1. Set the I ight switch knob to the OFF position.
2. Measure the resistances with an ohmmeter across the 81
terminal and 1 terminal, and across the 81 terminal and the T
terminal.
3. If infinity is not indicated, the combination switch is faulty.
Resistance
B1-1
(Switch knob at OFF Infinity
position) B1-T
3) Headlight Switch Continuity When Setting Switch Knob at
ON Position
1. Measure the resistance with an ohmmeter across the 81
terminal and 1 terminal, and across the 81 terminal and T
terminal.
2. If 0 ohm is not indicated, the combination switch is faulty.
Resistance
B1-1
(Switch knob at ON
Oohm
position) B1-T
4) Hazard Switch Continuity When Setting Switch Knob at OFF
Position
1. Set the hazard switch knob to the OFF position.
2. Measure the resistances with an ohmmeter across the 82
terminal and L terminal, and across 82 terminal and R
terminal.
3. If infinity is not indicated, the combination switch is faulty.
Resistance B2-L
(Switch knob at OFF
Infinity
position) B2-R
5) Hazard Switch Continuity When Setting Switch Knob at 1
Position
1. Set the hazard switch knob to the 1 position.
2. Measure the resistance with an ohmmeter across the 82
terminal and Rterminal.
3. If 0 ohm is not indicated, the combination switch is faulty.
Resistance B2-R
Oohm
(Switch knob at 1
position) B2-L
Infinity
6) Hazard Switch Continuity When Setting Switch Knob at 2
Position
1. Set the hazard switch knob to the 2 position.
2. Measure the resistance with an ohmmeter across the 82
terminal and Lterminal.
3. If 0 ohm is not indicated, the combination switch is faulty.
Resistance
B2-L
Oohm
(Switch knob at 2
position)
B2-R
Infinity
9-S21