Installation Instructions

M MOWER
B 1700·B21 00·B2400 WSM, 11770
Assembling Mower
A CAUTION
• Do not operate the rear gauge wheel adjusting lever (3)
without support by block (2).
1. Take out all mower components from the case, and assemble
the mower.
2. Support the mower deck with a block (2) as shown in the
figure.
3. Turn the anti-scalp wheel (1) sideway position, and set the
rear gauge wheel
(4) on the lowest cutting height.
4. Remove the a block.
5. Park the tractor on level ground, and set the rear wheels (5)
of the tractor at the outer position (6) as shown in the figure.
(1) Anti-scalp Wheel
(2) Block
(3) Rear Gauge Wheel Adjusting Lever
(4) Rear Gauge Wheel
(5) Rear Wheel
(6) Outer Position
B177FM15
(1) Front Hanger Bracket
Front Hanger Bracket
1. Attach the front hanger bracket (1) to the frame with M14
bolts.
(A) Outside
(B) Inside
(C) Thread Size: M12 x Pitch 1.25
(0) Thread Size: M12 x Pitch 1.75
Mid Hanger Bracket
1. Screw M 12 stud bolts (1) in the clutch housing.
2. Attach the mid hanger bracket (2) to the clutch housing with
spring washers and nuts.
(1) Stud Bolt
(2) Mid Hanger Bracket
31.4 N'm
Stud bolt
3.2 k~f.m
23.1 -Ibs
Tightening torque
68.6 N'm
Nut
7.0k~tm
50.6 -Ibs
2
pep
®mnillmJnffrn@
B177FM16
B177FM17
M-S8