Installation Instructions
M MOWER
B1700'B2100·B2400 WSM, 11770
DISASSEMBLING
AND
ASSEMBLING
(1)
Dismounting
Mower
A CAUTION
.. When dismounting
or
mounting the mower. park the tractor on
flat
ground. apply the parking brake. and
stop the engine.
Anti-scalp Wheel
1.
Start
the
engine, and
lift
the mower.
2. Turn
the
anti-scalp wheel (1) sideway position and set
the
rear gauge wheel (2) on the lowest cutting height.
3. Lower the mower, and stop the engine.
(When reassembling)
..
After
mounting
the
mower,
turn
the
anti-scalp
wheel
straight position.
B177FM37
2
(1) Anti-scalp Wheel (2) Rear Gauge
Wheel
(When reassembling)
..
Apply
grease
to
the
splines and grease
nipples
of
the
universal
joint
.
• Slide the universal
joint
back and forward
to
make sure the
universal
joint
is
locked securely.
Rear
Link and Universal Joint
1.
Disconnect the rear links (4), pulling the L-pin (2).
2.
Pull
back the coupler (1)
to
unlock, and remove
the
universal
joint
(3) from the mid PTa shaft.
3. Start
the
engine, and
shift
the
position
control
lever
to
"LIFT" position.
Front Link
1.
Push
down
the
link
fixing lever (2)
to
disconnect the
front
link
(3), pulling the L-pin (1).
2.
Remove the
front
link (3) from the stay (4).
(When reassembling)
.. Hook the
front
link
(3)
with
the
clevis pin section
to
front
end
of
the groove (5), and then turn the stopper (6)
as
shown in
the
figure.
.. Make sure the
link
fixing lever (2)
is
fixed
with
L-pin (1)
securely.
(4) Stay
(5) Groove
(6) Stopper
(1) L-pin
(2) Link Fixing Lever
(3) Front Link
B177FM38
(1) Coupler
(2) L-pin
(3) Universal
Joint
(4) Rear Link
M-S16