Installation Instructions

B1700·B2100·B2400 WSM,11770
DISASSEMBLING AND ASSEMBLING
(1) Separating Front Axle
6 FRONT AXLE
Draining FrontAxle Case Oil
1. Place oil pans underneath the front axle case.
2. Remove both right and left drain plugs (3) and filling plug (2)
to drain the oil.
3. Remove the right and left breather plugs.
4. After draining, reinstall the drain plugs (3).
5. Fi II with new oil up to the upper notch on the dipstick.
6. After filling, reinstall the filling plug and breather plugs.
(When reassembling)
.. Apply grease to the splines ofthe propeller shaft.
II IMPORTANT
.. After ten minutes. check the oil level again. add oil to
prescribed level.
.. Use KUBOTA SUPER UDT fluid or SAE 80. 90 gear oil.
Refer to "LUBRICANTS. FUEL AND COOLING WATER", (See
page G-8.)
Propeller Shaft
1. Loosen the clamp (5) and slide the propeller shaft cover (1),
(4) to the rear.
2. Tap out the spring pin (2), and then slide the coupling (3) to
the rear.
t.
(1 ) Breather Plug
(2) Filling Plug
with Dipstick
(3) Drain Plug
(A) Oil
level is acceptabel within this range.
Front axle
case oil capacity
(1) Propeller Shaft Cover
(2) Spring
Pin
(3) Coupling
3.71
3.9 U.S.qts.
3.3Imp.qts.
(4) Propeller Shaft Cover
(5) Clamp
(6) Propeller Shaft
3
B177F602
6-55