Installation Instructions

81700·82100'82400 WSM,11771
(2) Check Point of Every 300 Hours
G GENERAL
Changing Front Axle Case Oil
1. Place the oil pans underneath the front axle case.
2. Remove the both right and left hand side drain plugs (3) and
filling plug (2) to drain the oil.
3. Remove the right and left breather plugs.
4. After draining, reinstall the drain plugs (3).
5. Fill with new oil up to the upper notch on the dipstick.
6. After filling, reinstall the filling plug and breather plugs.
II IMPORTANT
• After ten minutes, check the oil level again, add oil to
prescribed level.
• Use KUBOTA SUPER UDTfluid or SAE 80, 90 gear oil.
Refer to "LUBRICANTS, FUEL AND COOLING WATER". (See
page DG·2.)
/
8177P321
(1)
8reather Plug
(2) Filling Plug
with Dipstick
(3) Drain Plug
(A) Oil level is acceptable within this range.
(3) Check Point of Every 400 Hours
Front axle case oil capacity
4.5.u
4.8 u.s. qts
4.0 Imp. qts
8177FG33
(1) Front Wheel Hub Cover
Lubricate Grease Fitting
1. Detach the cover, and apply bearing grease.
DG-3