Installation Instructions

B1700·B21 00·B2400 WSM, 11771
1 ENGINE
D ENGINE
SERVICING
1
_
_
D_is_ta_nc_e_:_" A_'_' I __ F_act_o_r_
y
_sp_e_c· l_
18
_
m
_
m
_
0.71 in.
10mm
0.39 in.
(3) Bi-speed Turn Cable
Factory spec.
Distance: "B"
(1) Spring Lock Pin
(2) Lock
Nut
(Reference)
Propeller Shaft Cover and Coupling and Drag Link on page
1-513 are altered as explained below.
Bi-speed Turn Cable
1. Remove the spring lock pin (1) and loosen the lock nuts (2)
and then remove
the bi-speed turn cable (3).
(When reassembling)
• When reassembling the bi-speed turn cable (3), make sure to
set the distance" A".
B177P323
17.7
to 34.5 N'm
Tightening torque Slotted nut
1.8 to 3.5 kgf·m
13 to 25.3 ft-Ibs
(When reassembling)
III IMPORTANT
• After tightening the slotted nut to the specified torque,
install the cotter pin as shown in the figure.
(2) Knuckle Arm
(3) Coupling
(1)
DragLink
(1) Propeller Shaft Cover
(2) Spring
Pin
DrClg Link
1. Remove the cotter pin and loosen the slotted nut.
2. Disconnect the drag link (1) with a pitman arm puller from
the knuckle arm
(2).
Propeller Shaft Cover and Coupling
1. Loosen the clamp and slide the propeller shaft cover (1) to
the rear.
2. Tap out the spring pin (2) and then slide the coupling (3) to
the rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft and
coupling
030F129
D1-S1