Installation Instructions

4 REAR AXLE
mREAR AXLE
B1700·B2100·B2400 WSM,11771
SERVICING
8mm
0.31 in.
Factory spec.
(1) Brake
Rod
(2) Spring
(3) Lever Holding Plate
(4) Bi-speed Turn Cable
(Reference)
Rear axle case mounting
39to44 N'm
Tightening
torque
4.0 to 4.5 k~.m
screws
29 to 33 ft- s
I
Distance: "B" Factory spec. I 19 mm
. ---L 0_.7_5_1n_. ---'
(5) Cable Support
(6) Differential Lock
Rod
(7) Rear Axle Case
(8) Bi-speed Turn Lever Rod
IDista nce : "A"
UBI!
Rear Axle Case on page 4-52 is altered as explained below.
Rear
Axle Case
1. Disconnectthe brake rod (1).
2. Remove the spring (2) and lever holding plate (3).
3. Loosen the lock nuts and remove the bi-speed turn cable (4)
from cable support (5).
4. Disconnect the differential lock rod (6).
5. Remove the rear axle case mounting screw.
6. Separate the rear axle case (7) from the differential case.
(When reassembling)
CD Apply liquid gasket (Three Bond 1208D or equivalent) to
joint face of the rear axle case and differential gear ease
after eliminating the water, oil and stuck liquid gasket.
CD When reassembling the bi-speed turn cable (4), make sure to
set the distance" A".
B177F410
D4-S1