Installation Instructions

B1700·B2100·B2400 WSM,11771
5 BRAKES
~ BRAKES
SERVICING
8mm
0.31 in.
(5) Cable Support
(6)
Differential Lock Rod
(7) Rear Axle Case
(8) Bi-speed Turn Lever Rod
Factory spec.
Factory spec.
I
19mm
0.75 in.
-----------'--------
(1) Brake Rod
(2) Spring
(3) Lever Holding Plate
(4) Bi-speed Turn Cable
(Reference)
Rear axle case mounting
39 to 44 N'm
Tightening
torque
4.0 to 4.5 kgf'm
screws
29 to 33 ft-I bs
I Distance:" A"
I Distance: "B"
Rear Axle Case with Brake Assembly on page 5-S5 is altered as explained below.
Rear Axle Case
1. Disconnect the brake rod (1).
2. Remove the spring (2) and lever holding plate (3).
3. Loosen the lock nuts and remove the bi-speed turn cable (4)
from cable support (5).
4. Disconnect the differential lock rod (6).
5. Remove the rear axle case mounting screw.
6. Separate the rear axle case (7) from the differential case.
(When reassembling)
• Apply liquid gasket (Three Bond 1208D or equivalent) to
joint face of the rear axle case and differential gear ease
after eliminating the water, oil and stuck liquid gasket.
• When reassembling the bi-speed turn cable (4), make sure to
set the distance" A".
II All
IIBlI
B177F410
D5-S1