Installation Instructions

B1700·B2100·B2400 WSM,11770
B177P184
6 FRONT AXLE
Bevel Gear Case, Axle Flange and Front Gear Case
1. Remove the knuckle arm (Left side).
2. Remove the axle flange (1) mounting screw~.
3. Remove the external snap ring (2).
4. Remove the bevel gear case (3) from front gear case (7).
5. Remove the bevel gear shaft (4) and ball bearing.
(When reassembling)
• Apply liquid gasket (Three Bond 1208D or equivalent) to
joint face of the axle flange (1) and front gear case (7) after
eliminate the water, oil and stuck liquid gasket.
• Tighten the axle flange mounting screws and nuts diagonally
in several steps.
• Install the oil seal (6) of bevel gear case, noting its direction
as shown in the figure below.
Axle flange mounting
23.6to 27.4 N'm
Tightening torque
2.4 to 2.8 kgf'm
screws
17.4 to 20.2 ft-Ibs
(1) Axle Flange
(2) External Snap Ring
(3) Bevel Gear Case
(4) Bevel Gear Shaft
(5) Thrust Collar
(6) Oil Seal
(7) Front Gear Case
B177F603
6-57