Installation Instructions
6
FRONT
AXLE
81700·82100·82400 WSM,11771
[2] BI-SPEED TURN
TYPE
(1) Separating Front Axle
Bi-speed Turn Cable
1.
Remove
the
spring lock pin (1) and loosen
the
lock nuts
(2)
and then remove
the
bi-speed
turn
cable (3).
(When reassembling)
.. When reassembling
the
bi-speed
turn
cable (3), make sure
the
distance
"A".
Draining Front Axle
Case
Oil
1.
Place
oil
pans
underneath the
front
axle
case.
2.
Remove both
right
and
left
drain plugs
(3)
and
filling
plug
(2)
to
drain the oil.
3.
Remove
the
right
and
left
breather
pi
ugs.
4.
After
draining, reinstall
the
drain plugs (3).
5.
Fill
with
new oil up
to
the
upper notch on
the
dipstick.
6.
After
filling, reinstall the
filling
plug and breather plugs.
III IMPORTANT
•
After
ten
minutes,
check
the
oil
level
again,
add
oil
to
prescribed level.
..
Use
KUBOTA
SUPER
UOT
fluid
or
SAE
80,90 gear oil.
Refer
to
"LUBRICANTS,
FUEL
AND
COOLING
WATER",
(See
page
OG-2,)
(1)
Breather Plug
(2) Filling
Plug
with
Dipstick
(3) Drain Plug
(A) Oil level
is
acceptable
within
this range.
18mm
0.71
in.
10mm
0.39 in.
4.51
4.8 U.S.qts.
4.0Imp.qts.
(3)
Bi-speed Turn Cable
Factory
spec.
Factory
spec.
Distance: "A"
Distance:
"B"
Front axle
case
oil capacity
(1)
Spring Lock
Pin
(2)
Lock
Nut
(Reference)
8177P323
06-57