Installation Instructions

B1700·B2100·B2400 WSM,11772
3 TRANSMISSION
Stay mounting screw
77.4to90.2 N'm
7.9to9.2 kgf'm
(M12)
57.1 to 66.5 ft-Ibs
Tightening
torque
Arm mounting bolt and
23.5
to 29.8 N'm
nut (M8)
2.4
to 2.8 kgf·m
17.3
to 20.5 ft-Ibs
23.5
to 29.8 N'm
Damper adjusting
nut
2.4 to 2.8 kgf'm
17.3 to 20.5 ft-Ibs
B177F324
DISASSEMBLING AND ASSEMBLING
[1] SEPARATING CENTER FRAME AND TRANSMISSION ASSEMBLY
HST Pedal (HST Type)
1. Disconnect the right hand side brake rod (1).
2. Remove the damper (2).
3. Remove the HST pedal spring assembly (3).
4. Tap out the spring pin (4) and remove the spring lock pin (5),
then draw out the HST pedal (6).
(When reassembling)
• Tap in the spring pin (4) as shown in the figure.
III NOTE
.. After reassembling the HST pedal spring assembly, must
adjust the spring force and check the pedal performace (See
page
3-S7, S8)
(1) Brake Rod
(2) Damper
(3)
HST Pedal Spring
assembly
[A] Outside
[B] Inside
(4) Spring
Pin
(5) Spring Lock Pin
(6) HST Pedal
E3-S3