Installation Instructions

7 STEERING
B 1700·B21 00·B2400 WSM, 11772
Valve Assembly and Ball Nut Assembly
1. Remove the valve housing mounting hex. head screws.
2. Draw out the valve assembly and ball nut assembly as a unit.
(When reassembling)
Valve housing mounting
39.2 to 49.0 N'm
Tightening torque 4.0
to 5.0 kgf'm
hex. head screw
28.9
to 36.2 ft-Ibs
88.3
to 107.9 N'm
Lock nut
9.0 to 11.0 k~f.m
65.1 to 79.6 -Ibs
Tightening torque
8.8
to 10.8 N'm
Plug
0.9 to 1.1 kgf'm
6.5 to 8.0 ft-Ibs
Ball Nut Assembly
1. Remove the lock nut (2).
2.
Remove the plug (3).
3. Pull out the ball nut assembly (4) with sleeve (5) and stub
shaft (6) from valve housing (1).
(When reassembling)
.. When tighten the lock nut and plug, use the PS lock nut
wrench and PS pi ug wrench (Refer to G-34) .
.. Be sure to tighten the plug to specified torque.
If the plug is tightened to excessive torque, it may cause
damage to the thrust races and thrust bearings.
B193P039
(1) Valve Housing
(2)
Lock Nut
(3) Plug
E7-S6
(4) Ball Nut Assembly
(5) Sleeve
(6) Stub Shaft