Installation Instructions

7 STEERING B 1700·B21 00'B2400 WSM, 11770
Fuel Tank
1. Disconnect the fuel hose between fuel filter and fuel tank at
the fuel filter side, then drain fuel completely.
2. Remove the fuel tank frame stay (1).
3. Disconnect the regulator and hazard unit connectors, and
remove the lead
wire for fuel gauge.
4. Disconnect the fuse box (4).
5. Dismount the overflow hoses (5) of fuel line.
6. Remove the tank flame (2) with fuel tank (3).
(1) Fuel Tank Frame Stay
(2) Fuel Tank Frame
(3) Fuel Tank
(4) Fuse Box
(5) Overflow Hose
17.7to34.3 N'm
Slotted
nut
1.8 to 3.5 kgf·m
13.0
to 25.3 ft-Ibs
Tightening torque
Pitman arm mounting
147.1 to 176.5 N'm
15.0to 18.0 kgf'm
nut
108.5 to 130.2 ft-Ibs
Step
1. Remove the lowering speed adjusting knob (3).
2. Remove the seat under cover (1).
3. Remove the rubber mat (2).
4. Remove the clutch spring and left hand step (4).
(1) Seat Under Cover (3) Lowering Speed Adjusting Knob
(2) Rubber
Mat (4) Step (LH)
Drag Link and Pitman Arm
1. Remove the slotted nut and disconnect the drag link (2) from
the pitman arm
(1).
2. Remove the pitman arm mounting nut and remove the
pitman arm with pitman arm puller (Code No. 07909-39011).
(When reassembling)
III IMPORTANT
• After tightening the slotted nut to the specified torque,
install the cotter pin as shown in the figure.
• Install the pitman arm to the sector gear shaft so that their
marks align.
(2) Drag Link
(1) Pitman Arm
7-S6