Operation Manual

BX25, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM
ENGINE
3EEABAB 1 P118A
(C)t~~u
3EEABAB 1 P119B
(A) (8)
r---- -
".:">.,~ -c
... , .•.. :.'.,'." "\ ()
...... \
~
(C)
(D)
~(a)
(b(ftt\~
3EEACAA 1 P088A
Correcting Valve and Valve Seat
• NOTE
• Before correcting the valve and seat, check the valve stem
and the I.D.
of valve guide section, and repair them if
necessary.
•
After correcting the valve seat, be sure to check the valve
recessing.
1) Correcting Valve
1. Correct the valve with a valve seat cutter.
0.785 rad
Valve face angle
Factory spec.
45
0
2) Correcting Valve Seat
1. Slightly correct the seat surface with a 0.785 rad (45°) valve seat
cutter.
2. Fitting the valve, check the contact position of the valve face and
seat surface with prussian blue. (Visual check) [If the valve has
been used for a long period, the seat tends to come in contact
with the upper side
of the valve face.]
3. Grind the upper surface of the seat with a 0.262 rad (15°) valve
seat cutter until the valve seat touches to the center
of the valve
face (so that (a) equals (b) as shown
in the figure.)
4. Grind the seat with a 0.785 rad (45 0) valve seat cutter again, and
visually recheck the contact between the valve and seat.
5. Repeat steps 3 and 4 until the correct contact is achieved.
6. Continue lapping until the seated rate becomes more than 70 %
of the total contact area.
IValve seat angle
Factory spec.
I0.785 rad
45
0
(1) Valve Seat Cutter (a) Identical Dimensions
(b) Valve Seat Width
(A) Check Contact
(c) 0.262 rad (15')
(8) Correct Seat Width (d) 0.785 rad (45·)
(C) Check Seat Surface
(D) Check Contact
W10283500
Valve Lapping
1. Apply compound evenly to the valve lapping surface.
2. Insert the valve into the valve guide. Lap the valve onto its seat
with a valve flapper
or screwdriver.
3. After lapping the valve, wash the compound away and apply oil,
then repeat valve lapping with oil.
4. Apply prussian blue to the contact surface to check the seated
rate. If it is less than 70
%, repeat valve lapping again .
• IMPORTANT
• When valve lapping is performed, be sure to check the valve
recessing and adjust the valve clearance after assembling
the valve.
W10288140
1-S45