Operation Manual

BX25, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM
TRANSAXLE
• Forward
.....•
!!'ll!l11lll!!!!lmli!1,t
......
,,:X ,,:V
:Z
3TAAAAFKP004A
(1) Cylinder Block (Pump) (7) High Pressure Relief Port (13) Power Steering Controller
A: A Port
(2) Swashplate
Plug (Forward) (14) Hydraulic Pump
B:BPort
(3) Piston
(8) Charge Relief Valve (15) Flow Priority Valve (Hydraulic
C: C Port
(4) Cylinder Block (Motor) (9) High Pressure Relief Port Control Valve)
D: D Port
(5) Check and High Pressure Plug (Reverse) (16) Position Control Valve
X: High Pressure
Relief Valve (Forward) (10) PTO Clutch Valve (17) Oil Strainer
Y: Low Pressure
(6) Check and High Pressure (11) PTO Relief Valve (18) Transmission Case
Z: FreeOil
Relief Valve (Reverse) (12) Oil Filter Cartridge
When the speed control pedal is stepped on and in forward, the variable swash plate is tilted as shown in figure
above.
As the pump cylinder block rotates with the input shaft, oil is forced out
of pump port B at high pressure. As
pressure oil enters motor port
D, the pistons, which align with port D, are pushed against the swashplate and slide
down the inclined surface.
Then the output shaft rotates with the motor cylinder block. This drives the machine forward and the angle
of pump
swash plate determines the output shaft speed.
As the motor cylinder block continues to rotate, oil is forced out
of motor port C at low pressure and returns to the
pump.
2-M5