Operation Manual
BX25. RCK54(P)-23BX. RCK60B-23BX, LA240, BT601, WSM
TRANSAXLE
Adjustment
of
HST
Neutral
Position
1.
Start the engine.
2.
Keep the engine
at
the maximum revolution.
3.
Shift the range shift lever (1) to "Hi" position (8).
4.
Loosen the locking screw (5).
• NOTE
•
When
adjusting
the
HST
neutral
position,
loosen
the
locking
screw
approximately
2
turns
counterclockwise
not
to
drop
the
nut
inside.
•
Make
sure
4WD
lever
is
2WD
before
making
adjustment.
(Forward
to
Neutral
Position)
5.
Depress the speed control pedal (3) to
"Forward"
speed position,
and release the foot from the speed control pedal
(3). Check that
the rear axle (or the wheel) stops rotating.
If the rear axle (or the wheel) does not stop rotating, move the
position
of
the locking screw (5) to the machine front side to stop
rotating.
(Reverse
to
Neutral
Position)
6.
Depress the speed control pedal (3) to "Reverse" speed position,
and release the foot from the speed control pedal
(3). Check the
rear axle (or the wheel) stops rotating. If the rear axle (or the
wheel) does not stop rotating, adjust the locking screw (5) to stop
rotating.
7.
After adjusting the neutral position, tighten the lock screw (5)
securely.
(1) Range Gear Shift Lever
(A)
4WD
"OFF" Position
(2) Front Wheel Drive
(8)
"Hi"
Position
(3) Speed Control Pedal
(e)
FORWARD
(4) Neutral Adjust Lever
(D)
REVERSE
(5) Locking Screw
(6) Screw Driver
W1012819
2-S10