Operation Manual

BX25, RCK54(P)-23BX, RCKSOB-23BX, lA240, BTS01, WSM
SAFETY INSTRUCTIONS
SAFETY STARTING
• Do not start the engine by shorting across starter
terminals or bypassing the safety start switch.
• Do not alter or remove any part
of machine safety
system.
• Before starting the engine, make sure that all shift
levers are
in neutral positions or in disengaged
positions.
• Never start the engine while standing
on ground.
Start the engine only from operator's seat.
SAFETY WORKING
• Do not work on the machine while under the influence
of alcohol, medication,
or other substances or while
fatigued.
• Wear close fitting clothing and safety equipment
appropriate to the job.
• Use tools appropriate to the work. Makeshift tools,
parts, and procedures are not recommended.
• When servicing is performed together
by two or more
persons, take care to perform all work safely.
•
Do not work under the machine that is supported
solely by a jack. Always support the machine by
safety stands.
• Do not touch the rotating or hot parts while the engine
is running.
• Never remove the radiator cap while the engine is
running, or immediately after stopping. Otherwise, hot
water will spout out from radiator. Only remove
radiator cap when cool enough to touch with bare
hands. Slowly loosen the cap to first stop to relieve
pressure before removing completely.
• Escaping fluid (fuel or hydraulic oil) under pressure
can penetrate the skin causing serious injury. Relieve
pressure before disconnecting hydraulic or fuel lines.
Tighten all connections before applying pressure.
•
Do not open high-pressure fuel system.
High-pressure fluid remaining
in fuel lines can cause
serious injury. Do not disconnect or attempt repair
fuel lines, sensors, or any other components between
the high-pressure fuel pump and injectors on engines
with high pressure common rail fuel system.
• High voltage exceeding 100 V is generated
in the
ECU, and is applied to the injector.
Pay sufficient caution to electric shock when
performing work activities.
2